Located in Golconda, Nevada.
Golconda is 15 miles east of Winnemucca, and only a mile from Interstate Route 80
I would HIGHLY prefer pickup here in Golconda, but may be able to deliver to Winnemucca or Battle Mountain.
MORE PHOTOS available on demand!
This is one used fiberglass bed cap for a pickup truck.
From my research, I THINK it's meant for a 1973-1987 General Motors "square body" pickup with a 6-1/2-foot "step side" bed.
Please measure your truck's bed and compare to this cap's listed dimensions below to be sure.
Made by “Protect-O-Top”
596 Ross Drive
Sunnyvale, California 94086
show contact info
It is very heavy and rugged.
The rear glass liftgate support arms work well, and latch into the open position.
The liftgate handle has a keylock, but I DO NOT have a key for it.
It is in good condition, with no cracks or other significant damage that I can see.
I just pressure-washed the cap, and 80-90% of the black mold that was on it came off.
The gelcoat cleans up VERY nicely for its age, with a little elbow grease, though.
See the last photo for an example of an area that was cleaned.
Dimensions of surface that mounts to the top of the pickup bed:
Overall length: 80-1/2”
Overall width: 63-7/8”
Inside width, at front: 50-⅝”
Inside width, at rear: 50-¼”
Width of lip across the bottom front of the cap: 1-⅞”
Height of center of cap, at its front: 25-½”
The front of the cap is perpendicular to the bed.
Thanks!
Darron
squarebody
square body
square-body
stepside
step side
step-side
bed cap
bed top
bed topper
camper shell
Whatsapp
