Located in Golconda, Nevada.
Golconda is 15 miles east of Winnemucca, and only a mile from Interstate Route 80
I would HIGHLY prefer pickup here in Golconda, but may be able to deliver to Winnemucca or Battle Mountain.
This is one used ladder / cargo / lumber rack for a small pickup truck.
It was cut down by a previous owner to fit the six-foot bed on a Chevy / Chevrolet S10, GMC S15 / Sonoma, or Isuzu Hombre mini pickup.
It MAY fit other trucks, as well (either as-is or modified), but please don’t ask me if it will fit your other model truck!
Please compare my measurements below to your truck’s bed!
It came on my 1997 Isuzu Hombre, which is dimensionally identical to a Chevy S10, or GMC S15 / Sonoma
Made of welded steel.
Actual dimensions:
Tubing Outer Diameter: 1-7/8"
Overall length, including "hoops" at rear: 121-3/4"
Overall length, from front of front transverse bar to rear of rear transverse bar, 116-3/4"
Inside width, on top, between side rails: 49-1/8"
Maximum pickup cab height, from top of truck bed to top of cab: 22-3/4"
Dimensions of angle-iron rails on bottom of rack, that sit on top of the pickup's bed rails:
Outside width, across top of rails: 2-1/2"
Overall length: 71-1/2"
Overall length, from front of rails to forward end of cutout notch on side of each rail: 67"
Width of the VERTICAL portions of the rack's bottom rail, across the OUTSIDE
(The measurement of your truck bed's top rails, across their INSIDE width should be at or greater than these measurements):
AT FRONT: 55-1/8"
AT REAR: 56-1/8"
Width of the HORIZONTAL portions of the rack's bottom rail, across the OUTSIDE
(The measurement of your truck bed's top rails, across their OUTSIDE width should be at or greater than these measurements):
AT FRONT: 59-3/4""
AT REAR: 60-3/4""
Keep in mind that the bed rail dimensions are not fixed, as there is some flex in the rack at this point.
Thanks!
Darron
Whatsapp
